CLEAR GATE - MODEL CP30
FOR OPENINGS 26.5” (67cm) - 41.5” (105cm)
ASSEMBLY INSTRUCTIONS
I
A
J
B
H
OPTION
STOP BRACKET
G
ONE-WAY
E
D
C
F
K
L
1. Install hinge bracket
(A) to wall (stationary
side of gate) using
Phillips screw (C)
2. Install second
screw (C) in
top of hinge
bracket
2
1
A
C or J
beginning 6 ” above
floor surface. (Use
ruler on left edge of
this sheet to measure
from floor).
securing it to
the wall.
C or J
OPTION: Long
screws (J) maybe be
used to attach gate to
stud through dry wall.
6 ”
B
E
3
4
F
2X
I
NOTE: THIS SIDE OF GATE HAS
THREE (3) HOLES - ONLY USE TOP AND
BOTTOM HOLES FOR THIS STEP
4. Hang gate by inserting hinge rod (B), through top
of mounted hinge bracket (A), through upper plastic
shoulder washer (F), through both eye bolts, through
lower plastic shoulder washer (F), and finally through
bottom of hinge bracket. To secure hinge, insert
key ring (I) through hole in end of hinge rod.
3. Insert eye bolts with nut and washer (E)
into top and bottom of hinge side gate
(side with three holes). Be sure nuts are
tight. Do not use middle hole for this step.
K
5
6
D
G
H
2X
L
LOOSEN AT TOP AND
BOTTOM OF GATE TO
ADJUST GATE WIDTH
OPTION
STOP BRACKET
ONE-WAY
D
5. Use Allen wrench (G) to unscrew
set screws on top and bottom of
gate to extend gate. LEAVE
6. Mount latch assembly (K) to gate using 3/4” bolts with serrated
washers (D). Attach wall mount for latch assembly (H) up
into part (K) that is now secure on gate. Slide gate out to
mark holes for (K) on attaching wall. (*OPTIONAL ONE WAY
BRACKET INSTALLED HERE) Then attach the wall mount of
latch assembly to wall using Phillips head screws (C).
SHIPPING TABS IN PLACE NOT TO
MAR GATE FINISH. You will remove
shipping tabs during final tightening.
SEE REVERSE
OPTION
STOP BRACKET
ONE-WAY
IF GATE IS INSTALLED AT TOP OF STAIRCASE:
Install one-way stop bracket (L) on one side of
wall mount latch if you wish to have gate open in
only one direction.
FOR GATE
OPERATION
INSTRUCTIONS
GATE IS RECOMMENDED FOR CHILDREN UP TO 24 MONTHS.
|