The IR-4101 includes these items:
CHANNEL VISION
Limited Warranty
Channel Vision Technology will repair or replace any defect in material or
workmanship which occurs during normal use of this product with new or rebuilt
parts, free of charge in the USA, for two years from the date of original purchase.
This is a no hassle warranty with no mail in warranty card needed. This warranty
does not cover damages in shipment, failures caused by other products not
supplied by Channel Vision Technology, or failures due to accident, misuse,
abuse, or alteration of the equipment. This warranty is extended only to the
original purchaser, and a purchase receipt, invoice, or other proof of original
purchasedatewill berequiredbeforewarrantyrepairsareprovided.
Accessories
1 - IR coax adaptor with IR receiver
1 - IR receiver holster
Mail in service can be obtained during the warranty period by calling (800) 840-
0288 toll free. AReturnAuthorization number must be obtained in advance and
canbemarkedontheoutsideoftheshippingcarton.
The IR-4101 is an IR coax adaptor that works with
Channel Vision’s IR coax engine to enable the
transmission of Infrared remote control signals onto
the same coax cable that delivers your cable TV.
Channel Vision’s IR coax engine can be found in the
following products: IR-4000, E2200IR, E3200IR,
E4200IR, and P-0321.
This warranty gives you specific legal rights and you may have other rights
(which vary from state to state). If a problem with this product develops during or
after the warranty period, please contact ChannelVisionTechnology, your dealer
oranyfactory-authorizedservicecenter.
1 - hole mount
500-167 rev A1
36”
Using the IR-4101 & P-0321
P-0321
How IR repeating works
The IR receiver is wired to
the IR hub which routes the
signal to IR emitters
Point an
IR remote control
at the IR receiver
Input from
CATV
Input from
Modulator
n
Expansio
e
n
Zo
l
a
b
lo
G
r
Pw
Model
P-1205
IR
Receiver
CHANNEL
VISIONTM
Model
P-0321
T
M
HANNEL
ION
S
I
C
Pat. Pending
V
l
a
b
lo
G
Power
CATV Input
MOD Input
IR
r
e
iv
e
c
Emitters
e
R
e
n
o
Z
C
A
D
2
1
+
m
0
5
2
IR Out
Output
CD player
And the emitter
repeats the IR signal
in the other room.
Be sure the emitter is attached directly over the component’s IR receiver.
To locate the IR receiver, shine a flashlight into the unit and look for the
sensor.
Digital CATV Box
1 - tabletop mount
IR-4101
IR receiver head
Features:
!
Specifications: (typical)
Plasma Proof IR receiver
Voltage Requirements:
IR Freq. range supported:
IR pickup range:
8 - 12 VDC
!
Compatible with: IR-4000, E2200IR, E3200IR, E4200IR, & P-0321
Versatile mounting accessaries: Install as
Very small receiver
!
30 kHz - 60 kHz
TV set
40 ft. @ 38kHz, 25 ft. @ 56kHz
In-cabinet tube type receiver
Unobtrusive desktop type receiver
IR receiver head dimensions: 0.65” x 0.35” x 0.25”
Color: Black
A0502
CATV - Selects the CATV input on the P-0321
MOD - Selects the modulator input on the P-0321
Specifications subject to change without notice.
|