I N S T A L L A T I O N I N S T R U C T I O N S
Model FSB-4101
INTERFACE BRACKET
VESA 200mm x 100mm / 100mm x 100mm
BEFORE YOU BEGIN
Prior to assembly, unpack carton completely and verify contents.
If you are missing any of the following components, or you have any questions about this installation, contact Chief
Manufacturing Customer Service at 1-800/582-6480
PART NO. 8804-000034 (Rev. E)
CHIEF MANUFACTURING INC.
1-800-582-6480 952-894-6280 FAX 952-894-6918
8401 EAGLE CREEK PARKWAY, STE 700
SAVAGE, MINNESOTA 55378 USA
©2005 Chief Manufacturing
Printed in USA 09/05
Installation Instructions
Model FSB-4101
NOTE: If the flat panel display has a table stand
Mount to Q2 System
attached, remove existing stand.
1. Install flat panel display, with interface plate attached,
on Q2 mount (see Figure 4).
Flush Mount Installation
2. Move latching flag of Q2 mount to secure display.
1. Secure the Interface Bracket to the Display using 1/8"
Nylon Spacers and M4 x 12mm screws
(see Figure 2).
Interface
NOTE: Length of mounting screws is dependant
upon length of spacer used.
Bracket
Display
Interface
Bracket
Display
Latching Flag
Q2 Mount
Figure 4:
Conversion to VESA 75mm Mounting/Centris®
Mounts
M4 x 12mm Screws(6)
1/8" Nylon Spacers (6)
1. Remove Phillips head screws and mounting buttons
from the interface bracket.
Figure 2:
Recessed Mount Installation
Interface
Bracket
Display
1. Place four Nylon spacers (3/8" or 3/4" as necessary)
over four mounting holes in Display (see Figure 3).
2. Secure the Interface Bracket to the Display using M4
x 20mm or M4 x 30mm screws depending upon
spacer used. (see Figure 3).
VESA Mount
Interface
Bracket
Display
Phillips Head
Screw (4)
Mounting Button
Figure 5:
2. Using M4 x 6mm screws, attach the interface bracket
to any VESA 75mm x 75mm mounting device.
M4 x 20mm Screws(6)
M4 x 30mm Screws(6)
3/8" or 3/4" Nylon Spacers(6)
Figure 3:
3
|