SCREENHOUSE SEtUp INStRUCtIONS
MODEL 2000008679
Before you begin
Raise the Screenhouse
• Read all instructions before set up.
• Extend each of the telescoping leg poles until they snap
into place. The screenhouse will raise as the leg poles are
extended. (Fig. 4)
• Select a level site clear of rocks, branches, and other hard or
sharp objects, to install your screenhouse.
WARNING: Keep clear of overhead power lines.
• Do not set up your screenhouse under trees because of potential
lightning strikes or falling tree limbs in inclement weather.
• Secure with all stakes and guylines provided to prevent property
damage or personal injury.
2
• For best results in windy conditions, position narrow end of
screenhouse into the wind.
• Do not drop screenhouse.
Lock Button
• Do not bounce screenhouse bag on its end to remove
screenhouse, as these actions may damage the frame.
• THIS RECREATIONAL PRODUCT REQUIRES A MINIMUM OF TWO
PEOPLE TO ASSEMBLE.
• Under no circumstances should this product be used to cover
automobiles, marine products or similar items.
CAUTION: Avoid pinch points when opening and closing the
screenhouse frame.
Fig. 4
Description
Repair Kit
Description
Repair Kit
Stake the Screenhouse
Plastic Clip 16 mm
Plastic Clip 20 mm
Fabric Repair Kit
Plastic Corner Joint
Fabric Joint Cover
5010000845
5010000846
5010000852
5010000853
5010000855
• Secure screenhouse by driving stakes through the
webbing loops sewn to the screenhouse base.
(Fig. 5 and Fig. 6 )
3
• Keep the floor taut.
Extend the Screenhouse
Frame
1
• Stand the screenhouse upright with the hub assembly at
the top. (Fig. 1)
• Unfold the arms of the screenhouse downward until they
lay flat on the ground. (Fig. 2)
• Fully extend the arms of the screenhouse away from the
center hub till the telescoping pole sections are locked in
place. (Fig. 3 and Fig. 3A)
Fig. 5
Fig. 1
Fig. 2
Webbing Loop
Screenhouse
Stake
Fig. 3A
Fig. 6
(continued on other side)
Fig. 3
|