GX-65
GUITAR AMPLIFIER
OWNER’S MANUAL
Congratulations!
You are now the proud owner of the Crate GX-65 guitar amplifier. This rugged ampli-
fier delivers serious clean and distorted sounds through its premium 12” Crate Custom
speaker. Channel selection, Crate’s exclusive Shape circuit, and reverb on/off are con-
trollable by the supplied three-button footswitch. An insert jack allows virtually noise-free
connection of your favorite effects.
Like all Crate products, your GX-65 is designed by musicians and built using only
the best components. Extensive testing at the hands (and ears) of skilled technicians
and musicians insures you that this amplifier is the absolute best it can be.
In order to get the most out of your new amplifier, we strongly urge you to go over
the information contained in this manual before you begin playing.
And thank you for choosing
GX-65 Amplifier
11
12
13
14
15
16
17 18
15: INSERT: Use this jack to connect an exter-
nal effects device to the amplifier. Use a stereo
1/4” male Y-cord: ring = send, tip = return, sleeve
= ground. See the illustration to the right for
more information.
22: REVERB FOOTSWITCH JACK (rear
panel, not shown): Use this jack to connect the
mono 1/4” plug of the supplied three-button
footswitch to the amplifier for remote control of
the reverb on and off.
16: EXT. SPEAKER: Use this jack to connect an
extension speaker cabinet to the amplifier. This
jack is wired in series with the internal speaker.
Connecting to the Insert jack:
The Insert jack (#15) lets you patch external
effects into the amplifier just prior to its power
amp stage. Use Crate’s STP201, STP202 or
STP203 stereo-to-mono Y-cord or an adapter
such as Crate’s YPP117 and 2 1/4” mono signal
cables to connect to the effect as shown below.
17: POWER ON LED: This LED illuminates
when the amplifier is turned on.
18: POWER SWITCH: Use this switch to turn
the amplifier on (top of the switch depressed) an
off (bottom of the switch depressed).
19. POWER CORD (rear panel, not shown):
The grounded power cord should only be
plugged into a grounded power outlet that meets
all applicable electrical codes and is compatible
with the voltage, power and frequency require-
ments stated on the rear panel. Do not attempt
to defeat the safety ground connection!
Stereo-to-mono Y-cord:
Y-adapter and 2 cables:
TIP
RING
SLEEVE
RETURN
TIP
to Insert
jack
to Insert
jack
SEND
RING
GROUND
SLEEVE
(STP201, 3'
STP202, 6'
STP203, 9')
(YPP117)
20: FUSE (rear panel, not shown): The fuse
protects the amplifier against damages caused
by power overload conditions. If the fuse fails,
replace it only with the same size and type fuse.
If the fuse fails repeatedly check the AC source;
if it’s okay, contact your Crate dealer for service
information.
(1/4"-TO-1/4"
21: CHANNEL SELECT / GAIN FOOTSWITCH
JACK (rear panel, not shown): Use this jack to
connect the stereo 1/4” plug of the supplied
three-button footswitch to the amplifier for
remote control of the Channel Select and Gain
Select settings.
MONO SHIELDED
CABLES)
to
to
effect
"IN"
to
to
effect
"IN"
effect
"OUT"
jack
effect
"OUT"
jack
jack
jack
External Effect
External Effect
GX-65 Amplifier
GX-65 TECHNICAL SPECIFICATIONS
Output Power Rating
65 watts RMS @ 5% THD 8 ohms minimum external load
Speaker Size and Rating
Input Impedance
(1) Custom Design 12”, 8 ohms
470k ohms
Maximum Input Signal Level Accepted
Total System Gain
7 volts, peak-to-peak
Overdrive Channel: 110dB all controls @10, Gain 2; 88dB Gain 1
Clean Channel: 58dB all controls @10
Overdrive Channel:
Clean Channel:
Low Control:
Shape Control:
High Control:
11dB Range @ 80Hz
Proprietary Circuit
10dB Range @ 10kHz
Low Control:
Mid Control:
High Control:
22dB Range @ 80Hz
14dB Range @ 600Hz
28dB Range @ 10kHz
Input Power Requirements
Cabinet Size and Weight:
120 VAC, 60Hz, 90VA
100/115VAC, 50/60Hz, 90VA
230VAC, 50/60Hz, 90VA
17-1/2” H x 20” W x 11” D, 34 lbs.
The GX-65 is covered with a durable black Tolex material: wipe it
clean with a lint-free cloth. Never spray cleaning agents onto the
cabinet. Avoid abrasive cleansers which could damage the finish.
CAUTION
PRECAUCION
ATTENTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
RIESGO DE CORRIENTAZO
NO ABRA
RISQUE D'ELECTROCUTION
NE PAS OUVRIR
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOIS-
TURE. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER. NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
PRECAUCION: PARA REDUCIR EL RIESGO DE INCENDIOS
O
DESCARGAS
LA
ATTENTION: PROTÉGEZ CET APPAREIL DE LA PLUIE ET DE L'HUMIDITÉ
AFIN D'ÉVITER TOUT RISQUE D'INCENDIE OU D'ÉLECTROCUTION. POUR
REDUIRE D'ELECTROCUTION NE PAS ENLEVER LE COUVERCLE. AUCUNE
PIECE INTERNE N'EST REPRABLE PAR L'UTILISATEUR. POUR TOUTE
REPARATION, S'ADRESSER A UN TECHNICIEN QUALIFIE.
ELECTRICAS, NO PERMITA QUE ESTE APARATO QUEDE EXPUESTO
A
LLUVIA
O
LA HUMEDAD. PARA DISMINUOIR EL RIESGO DE CORRIENTAZO.
NO ABRA LA CUBIERTA. NO HAY PIEZAS ADENTRO QUE EL USARIO PUEDO
REPARAR DEJE TODO MANTENIMIENTO A LOS TECHNICOS CALIFICADOS.
IMPORTANT SAFETY INSTRUCTIONS
• READ, FOLLOW, HEED, AND KEEP ALL INSTRUCTIONS AND WARNINGS.
• DO NOT OPERATE NEAR ANY HEAT SOURCE AND DO NOT BLOCK ANY VENTILATION OPENINGS ON THIS APPARATUS. FOR
PROPER OPERATION, THIS UNIT REQUIRES 3” (75mm) OF WELL VENTILATED SPACE AROUND HEATSINKS AND OTHER AIR
FLOW PROVISIONS IN THE CABINET.
• DO NOT USE THIS APPARATUS NEAR SPLASHING, FALLING, SPRAYING, OR STANDING LIQUIDS.
• CLEAN ONLY WITH LINT-FREE DAMP CLOTH AND DO NOT USE CLEANING AGENTS.
• ONLY CONNECT POWER CORD TO A POLARIZED, SAFETY GROUNDED OUTLET WIRED TO CURRENT ELECTRICAL CODES AND
COMPATIBLE WITH VOLTAGE, POWER, AND FREQUENCY REQUIREMENTS STATED ON THE REAR PANEL OF THE APPARATUS.
• PROTECT THE POWER CORD FROM DAMAGE DUE TO BEING WALKED ON, PINCHED, OR STRAINED.
• UNPLUG THE APPARATUS DURING LIGHTNING STORMS OR WHEN UNUSED FOR LONG PERIODS OF TIME.
• ONLY USE ATTACHMENTS, ACCESSORIES, STANDS, OR BRACKETS SPECIFIED BY THE MANUFACTURER FOR
SAFE OPERATION AND TO AVOID INJURY.
• WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK OR FIRE, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE..
• SERVICE MUST BE PERFORMED BY QUALIFIED PERSONNEL.
• OUR AMPLIFIERS ARE CAPABLE OF PRODUCING HIGH SOUND PRESSURE LEVELS. CONTINUED EXPOSURE TO HIGH SOUND
PRESSURE LEVELS CAN CAUSE PERMANENT HEARING IMPAIRMENT OR LOSS. USER CAUTION IS ADVISED AND EAR PRO-
TECTION IS RECOMMENDED IF UNIT IS OPERATED AT HIGH VOLUME.
EXPLANATION OF GRAPHICAL SYMBOLS:
EXPLICACION DE SIMBOLOS GRAFICOS:
EXPLICATION DES SYMBÔLES GRAPHIQUES:
"IT IS NECESSARY FOR THE USER TO REFER TO THE INSTRUCTION MANUAL"
“ES NECESARIO QUE EL USUARIO SE REFIERA AL MANUAL DE INSTRUCCIONES.”
"REFERREZ-VOUS AU MANUAL D'UTILISATION"
"DANGEROUS VOLTAGE"
“VOLTAJE PELIGROSO”
"DANGER HAUTE TENSION"
=
=
Crate continually develops new products, as well as improves existing ones. For this reason, the
specifications and information in this Crate manual are subject to change without notice.
©1998 SLM ELECTRONICS, A DIVISION OF ST. LOUIS MUSIC, 1400 FERGUSON, ST. LOUIS, MO. 63133
P/N 47-475-04 • 030603
|