ELECTRICAIRE
WARM AIR HEATING SYSTEM
Models: R7/47 - 7kW, R8/55 - 8kW, R10/73 - 10kW,
R12/84 - 12kW, R15/104 - 15kW
USER INSTRUCTIONS
IMPORTANT
PLEASE READ THIS LEAFLET CAREFULLY AND
RETAIN FOR FURTHER USE. NOTE ALSO THE
INFORMATION GIVEN ON THE HEATER
• WARNING - THE SURFACES ON THIS HEATER CAN BE HOT.
• This heater meets BS 3456 safety requirements. However, any heater type becomes hot in normal operation. Care
must be taken to ensure that prolonged skin contact with the heater does not occur.
WHERE YOUNG CHILDREN, INFIRM PERSONS, OR THE AGED ARE LIKELY TO BE LEFT UNSUPERVISED IN
THE VICINITY OF THE HEATER WE RECOMMEND THAT A GUARD IS FITTED. Contact your installer or the
manufacturer for further advice.
• THIS APPLIANCE IS EXTREMELY HEAVY. THE FLOOR MUST BE CHECKED TO ENSURE THAT IT IS CAPABLE
OF BEARING THE WEIGHT OF THE UNIT, UP TO 750KG (¾ TON). DO NOT UNDER ANY CIRCUMSTANCES
ATTEMPT TO MOVE OR REPOSITION THIS HEATER WITHOUT SEEKING EXPERT ADVICE.
•
•
To maintain stability, it is essential that the heater is placed on a level surface.
The heater must be installed where it is possible for switches and other controls to be touched by a person in a
bath or shower.
•
IMPORTANT - Due to the newness of materials the heater will produce a slight smell for the first few days of operation.
ROOMS MUST BE WELL VENTILATED AND YOUNG CHILDREN, CAGED BIRDS, OR PERSONS WITH
RESPIRATORY COMPLAINTS MUST NOT REMAIN IN CLOSE PROXIMITY TO THE HEATER DURING THE FIRST
48 HOURS OF THE COMMISSIONING PERIOD.
• IF, DURING ANY REASSEMBLY OF THE HEATER, A PART OF THE THERMAL INSULATION SHOWS DAMAGE
OR DETERIORATION WHICH MAY IMPAIR SAFETY, IT SHOULD BE REPLACED BY AN IDENTICAL PART.
• The heater must stand at least 50mm clear of any walls and 150mm below ceilings.
MAINTENANCE
A washable filter is fitted to ensure the warm air distributed is clean
and free from dust. The filter is located in the detachable lower
panel and should be washed in warm soapy water at least twice a
year (see Fig. B). The filter panel can be removed by pulling the top
end away from the heater and lifting out the location hooks.
To maintain the appearance of the heater, wipe occasionally with
a dry cloth when the heater is cool. Do not use abrasive powders
or furniture polish.
IMPORTANT - Do not remove any panel before isolating the heating
unit from all electrical supplies. Additional maintenance should
only be carried out by a trained engineer or electrician. When
required contact your local electricity board or the installer. Regular
inspection should take place, at least every two years.
ROOM ENVIRONMENTAL
CONTROLS
The installation may be fitted with several additional environmental
controls.
A room thermostat may be fitted in the room. This thermostat controls
the operation of the heater fan. Adjust the setting until a comfortable
environment is achieved.
Note however the higher the thermostat setting the higher the
running costs.
Where duct work is installed individual rooms will be fitted with
supply air registers. If a room is not in use the supply registers can
be closed.
Installer Note: Please ensure that the USER INSTRUCTIONS are handed to the
User when you have completed the installation if applicable, or left with the heater if the
building is unoccupied when the installation is carried out.
User Note: These instructions give important advice on how to get the best out of your
new heater. Please read them carefully and keep them in a safe place for future reference.
AfterSalesService: Your product is guaranteed for one year from the date of purchase.
We undertake to repair or exchange this product free of charge within this period providing
the product has been installed and operated in accordance with the manufacturers instructions.
Should you require after sales service, please contact our customer services help desk,
whose details are listed below.
Please do not return a faulty part or product, as this may result in loss or damage, which
may cause a delay in providing service.
Let us know the fault, quoting the model number and Serial No. together with your installation
address and telephone number, and we will take appropriate action.
ELECTRICAIRE
Customer Helpline
Product Sales
Head Office
Tel: (0870) 7270 101
Tel: (0870) 7270 103
Tel: (0870) 0777 117
Fax: (0870) 7270 102
Fax: (0870) 7270 104
Fax: (0870) 7270 109
Glen Dimplex UK Ltd,
Millbrook House,
Grange Drive,
Hedge End,
Southampton,
Hampshire,
SO30 2DF
71035
Issue 7 : 02.06
© Glen Dimplex UK Limited
All rights reserved. Material contained in this publication may not be reproduced in whole or part, without prior permission in writing from Glen Dimplex UK Limited.
|