Hi Res ECL Buffer DIP Switch Settings
Verify that the Hi Res ECL Buffer internal DIP Switch settings are correct for
your system application. To open the plastic housing, insert the flat blade of a
screw-driver, or similar object, into the slot recess at either end of the enclosure
and gently pry the halves apart. Once opened, orient the assembly so that the
internal DIP switches match the orientation in the diagram below. Use the
diagram and the table beneath it to verify or change the settings as required. An
incorrect setting will not cause damage to the Hi Res ECL Buffer or the system
being interfaced. Once settings are complete, snap the halves of the enclosure
together.
User's Guide
SW1
2
SW2
SW3
2
SW4
SW5
Workstation
1
3
X
X
X
X
1
2
X
X
3
X
X
1
3
X
X
X
1
2
1
2
MBC - SUN/APOLLO ON ON
OFF
OFF
ON OFF
ON OFF
OFF ON OFF ON
ON OFF OFF ON
OFF ON OFF ON
MBC - WANG WIIS
IBM 3472/77 MONO
ON ON
ON OFF
ON OFF ON ON OFF
ON ON
IBM 3472/77 COLOR OFF ON
X
OFF ON ON OFF ON OFF ON
MBC - SIGMA LVIEW ON OFF ON ON OFF ON ON OFF
X
X
OFF ON OFF ON
ON OFF OFF ON
X = No Effect
MBC - NCD19 MONO ON ON
X
OFF
X
X
ON OFF
Hi Res ECL Buffer
P/N 26-177-01
EXTRON ELECTRONICS
1230 South Lewis Street
Anaheim, CA 92805
(714) 491-1500 FAX (714) 491-1517
U.S.A.
EXTRON ELECTRONICS, EUROPE
Beeldschermweg 6C
3821 AH Amersfoort
+31-33-453-4040 FAX +31-33-453-4050
The Netherlands
EXTRON ELECTRONICS, ASIA
41B Kreta Ayer Road
Singapore 089003
+65-226-0015 FAX +65-226-0019
Singapore
79-09
68-057-01
Rev. G3
|