The hole on the playing
k Leg Ass
surface should point to tube
POINTS AND SCORING:
A
on the frame assembly.
Chuck-O - 3 points - A Chuck-O is a beanbag
that is tossed through the hole in the board or is
knocked in by a subsequently tossed beanbag.
The entire bag must pass through the hole.
E
E
INSTRUCTIONS
Ages: 8+ Players: 2-4
ASSEMBLY / ASSEMBLAGE / MONTAJE
OBJECTIVE: Be the first player or team to
score 21 points by tossing beanbags through
the hole in the game board or landing them on
top of the game board.
L
L
On the Board - 1 point - A beanbag that is not a
Chuck-O but lands with the bag resting on the
game board.
CONTENTS
E
h to the tubes with the
Frame Assembly
A – tube - 1pc. (19.5”)
Step 2: Unroll the game surface and
lay it on top of the frame assembly.
Align the holes on the game surface
with the holes on the frame
assembly, push the plastic rivets
through the game surface into the
frame assembly. The rivets should
snap into place. Attach the “C”
channel foam piece as shown.
“O” channel foam
connectors to create back leg assembly.
D
L
L
The back leg assembly attaches to the open
connctors on tube on the frame assembly.
Scratch - 0 points - A beanbag that lands
anywhere other than on the board or in the
hole, is a scratch.
B
C
– tube - 1pc. (19.5”)
– tube - 4pcs. (13.5”)
SET-UP: Unfold the Chuck-O Splash game
board and place it about 20 feet away from you
in the the pool. If your pool isn’t that big, place
the game board near the opposite edge of the
pool from where you are, or get out of the pool
and play from the ground. Chuck-O Splash may
be played with either 2 or 4 players, divided into
2 teams. Each team chooses a color of
A
SCORING: The game score is tallied at the end
of every round. Players or teams only score the
difference between the highest and lowest
player or team’s score. For example, if Player
/Team A got one Chuck-O and two On the
Board for a total of five points, and Player/Team
B got only two On the Board for two points,
then Player/Team A would score three points (5 -
2 = 3).
D – tube - 1pc. (12”)
Splash is now
Adjust the back leg to
on for play.
E
– tube - 2pc. (5.75”)
Make sure rivet holes
are facing the same
direction on all tubes
and connectors.
beanbags to use throughout the game.
I
– “I - shaped“ connector - 2pcs.
– “L - shaped“ connector - 6pcs.
The Chuck-O Splash game board will float
around during play. Players should all throw
from the same spot in order to keep things fair.
L
I
I
Net Assembly
WINNING: The first player or team to have 21
points at the end of a round wins! In the event
of a tie, play additional rounds until one player
or team has a higher score than the other at the
end of a round.
PLAY: A game consists of a series of rounds.
One round consists of all six beanbags being
tossed at the game board.
– Game Surface - 1pc.
– plastic rivets - 22pcs.
x22
Two Players: Both players toss their three
beanbags at the game board, taking turns and
throwing one beanbag per turn.
w close the leg trapping the bags in
This is not a lifesaving device. Do not leave child
unattended while device is in use.
– “C” channel foam - 1pc.
– “O” channel foam - 1pc.
– Floating beanbags - 6pcs.
Four Players: Each player tosses a beanbag at
the game board, taking turns between teams.
The net assembly consists of
s; the upper ring and the
ng/net. With the upper ring on
e game surface and the lower
under the game surface,
h the two together. The net
assembly should snap into place
firmly on the game surface.
L
L
©2008 Fundex Games, Ltd.
P.O. Box 421309 • Indianapolis, IN 46242
MADE IN CHINA
Questions or comments? Write to us at the address above,
In the next round, the player or team that
scored points in the previous round tosses first.
If neither player or team scored, the player who
tossed last in the previous round tosses first in
the next round.
I
Step 1: Attach
Attach tubes
tubes with connectors as shown.
call 1.800.486.9787 or email [email protected]
In an effort to continually improve our products, items may vary from those shown.
A
B
L
and
with the connectors.
ITEM NO. 0873-00-13
|