Edelbrock Automobile Parts 9339 User Manual

5. Install gasket and manifold onto engine  
using four (4) M6.1X1” flange head  
screws supplies in kit. See Fig 2.  
Figure 2.  
INSTRUCTION SUPPLEMENT FOR  
2001-LATER YAMAHA RAPTOR  
Removing stock carburetor and cables  
1. Make sure fuel petcock is in “off”  
position. Remove seat, front  
fenders and fuel tank.  
2. Remove throttle cables paying  
close attention to routing, as the  
new cables will need too be routed  
the same.  
3. Remove stock carburetors.  
4. Remove stock manifolds and air  
boots coming from air box.  
5. Stuff a dry, clean rag into the  
intake manifold to keep debris from  
entering engine.  
6. Remove stock air box clamps from air  
boots and install onto rubber hoses  
attached to plenum. See Fig 3.  
Figure 3.  
6. Remove two (2) bolts holding air  
box in place.  
Installing the Edelbrock Induction kit  
1. Install the provided throttle cables into  
OEM throttle housing (If using thumb  
throttle kit) or for twist throttle, install  
throttle cables into supplied throttle  
housing and onto handle bars.  
2. Remove the hex pipe plug from the  
carb cap using a 11mm or 7/16 wrench.  
Do not discard plug, as it will be  
needed later. Install the metering  
adjustment tool included in the  
hardware kit. Do not over-tighten as  
damage may occur to cap.  
3. Install provided fuel line onto fuel inlet  
banjo and secure with pinch clamp.  
4. Install rubber flange onto manifold  
using supplied bolts and washers. See  
Fig 1.  
7. Place plenum onto front of air box and  
tighten clamps. Make sure rubber  
hoses are pushed all the way onto air  
box.  
8. Place Edelbrock carburetor into  
manifold. Do not tighten clamp yet.  
9. Stretch rubber hose onto front of carb.  
Figure 1.  
Thumb Throttle Installation  
1. Remove the cable bracket end from  
cable bracket using #2 phillips.  
2. For thumb cable installation, install  
cable end into the 4:00 position of  
the cable wheel and the  
shouldered end into the bottom slot  
of the cable bracket and secure by  
replacing cable bracket and Phillips  
screw. See Fig 4.  
Figure 4.  
 

Eagle Electronics Fish Finder UltraNavGPS User Manual
Edirol Musical Instrument UA 1000 User Manual
Eicon Networks Network Card CTbus User Manual
EVGA Computer Hardware 123 CD E635 User Manual
Fiesta Gas Grill EZT34545 P310 User Manual
GE Cordless Telephone 25932EE1 User Manual
GE Monogram Refrigerator Bottom Mount Built In Refrigerators User Manual
Generac Portable Generator 005982 0 User Manual
Generac Power Systems Portable Generator 4703 User Manual
GE Range 164D3333P200 3 User Manual