Edelbrock Automobile Parts Carburetor User Manual

INSTRUCTION SUPPLEMENT FOR 2003-  
LATER POLARIS PREDATOR  
Removing stock carburetor and cables.  
1. Remove seat and gas tank. Make sure fuel  
petcock is in “off” position.  
2. Remove throttle cable paying close attention  
to routing, as the new cable(s) will need too  
be routed the same.  
Thumb Throttle Instructions  
NOTE: #3196 KIT REQUIRES THE USE OF  
A SUZUKI THUMB THROTTLE HOUSING.  
PART #57100-07G00 CAN BE ORDERED  
FROM ANY SUZUKI DEALER.  
3. Remove stock carburetor and stock throttle  
housing. Stuff a clean, dry rag into manifold  
to keep debris out of motor.  
1. Thread new throttle cable into housing and  
insert cable end into throttle lever.  
Twist Throttle Instructions  
2. Install cable into cable wheel on carburetor  
in the 4:00 position and secure cable into  
lower slot on cable bracket by replacing end  
piece and Phillips screw. See figure 6.  
1. Install the throttle cables into the supplied  
throttle housing and place onto clean  
handlebar end.  
2. Route throttle cables through frame as stock  
cable was routed.  
3. Install the pull cable into the 4:00 position  
and the return cable end into the 1:00  
position of the cable wheel. Secure cables  
to cable bracket by replacing end piece and  
Phillips screw. See figure 2.  
NOTE: SEE FIGURE 1 TO IDENTIFY CABLES.  
The bottom cable is the pull cable.  
Figure1.  
Carburetor installation  
Figure 2.  
 

EVGA Computer Hardware P55 LE User Manual
Extron electronic Stereo Amplifier IR 102 User Manual
Extron electronic Stereo Equalizer CVEQ 100 D User Manual
Extron electronic Switch FPC 5000 User Manual
Fellowes Computer Keyboard 8060101 User Manual
GE Double Oven EER2000 User Manual
Gefen Network Card Component Audio to HDMI Adapter User Manual
GE Freezer WMR04GAV User Manual
GE Home Security System 45227 1 User Manual
GE Monogram Double Oven ZET857DBSB User Manual