TABLE OF CONTENTS
IMPORTANT SAFETY INSTRUCTIONS…………………………………………………1
PREPARING YOUR ICE MAKER FOR USE
IMPORTANT SAFETY TIPS.……………………………………………………………….2
GETTING TO KNOW YOUR UNIT………………………………………………………..3
OPERATING PROCEDURES & MAINTENANCE
UNPACKING YOUR ICE MAKER ..………….…………………………………………...4
CONNECTING YOUR ICE MAKER……………….……….……………………………..4
CLEANING AND MAINTAINING YOUR ICE MAKER….……………………………….4
USING YOUR ICE MAKER……………….……..………………………………………...5
TROUBLESHOOTING..……………………….……………………………………………5
TECHNICAL SPECIFICATIONS & CIRCUIT DIAGRAM…..……………..….………..6
WARRANTY…………………………..……….………………………………………….…7
PREPARING YOUR ICE MAKER FOR USE
IMPORTANT SAFETY TIPS
When using electrical appliances, basic safety precautions should be followed to reduce the
risk of fire, electric shock, and/or injury to persons or property. Read all instructions before
using any appliance.
z
Do not operate this or any other appliance with a damaged cord.
Connect to properly polarized outlets only. No other appliance should be plugged into the
same outlet. Be sure that the plug is fully inserted into the receptacle.
z
z
Do not run cord over carpeting or other heat insulators. Do not cover the cord. Keep cord
away from traffic areas, and do not submerge in water.
We do not recommend the use of an extension cord, as it may overheat and become a
fire risk. If you must use an extension cord, use a cord of No.14 AWG minimum size and
rated for no less than 1875 watts.
z
z
z
Unplug the ice maker before cleaning it or making repairs.
Exercise caution and use reasonable supervision when appliance is used near children.
Do not clean your ice maker with flammable fluids. The fumes can create a fire hazard or
explosion.
z
z
Do not tip over.
If the ice maker is brought in from outside in wintertime, give it a few hours to warm up to
room temperature before plugging it in.
2
GETTING TO KNOW YOUR UNIT
1. Cover:
Features a transparent window for interior visibility.
2. Ice shovel.
3. Ice scoop.
4. Control Panel:
Easy to use, with touch controls.
A. Ice size indicators: Small, Medium, and Large.
B. Add water light: when lit, add water.
C. Ice-full light.
D. Power indicator
E. Power button.
F. Ice size selector button.
5. Water drain cap:
For draining water from water reservoir.
1
6. Air vent.
7. Ice basket.
2
3
7
6
4
5
A
B
F
C
D
E
3
OPERATING PROCEDURES & MAINTENANCE
UNPACKING YOUR ICE MAKER
1. Remove the exterior and interior packaging. Check that ice basket and ice scoop is
included. If any parts are missing, please contact customer service.
2. Clean the interior with lukewarm water and a soft cloth. Take out the ice basket and clean
it .
3. Find a location for your ice maker that is protected from direct sunlight and other sources
of heat (e.g., stove, furnace, radiator). Place the ice maker on a level surface. Maker sure
that there is at least 5 inches of space between the back and sides of your ice maker and
the wall.
4. Allow one hour for the refrigerant fluid to settle before plugging ice maker in.
5. The appliance must be positioned so that the plug is accessible.
CONNECTING YOUR ICE MAKER
DANGER
!
* Improper use of the grounded plug can result in the risk of electrical shock. If the
power cord is damaged please call customer service.
1. This unit should be properly grounded for your safety. The power cord of this appliance is
equipped with a three-prong plug which mates with standard three prong wall outlets to
minimize the possibility of electric shock.
2. Plug your appliance into an exclusive, properly installed, grounded wall outlet. Do not
under any circumstances, cut or remove the third (ground) prong from the power cord. Any
questions concerning power and/or grounding should be directed toward a certified
electrician.
3. This appliance requires a standard 110~120 volt, 60Hz electrical outlet with three-prong
ground.
CLEANING AND MAINTAINING YOUR ICE MAKER
Before using your ice maker, it is strongly recommended to clean it thoroughly.
1. Take out the ice basket.
2. Clean the interior with diluted detergent, warm water and a soft cloth.
3. The outside of the ice maker should be cleaned regularly with a mild detergent solution
and warm water.
4. Dry the interior and exterior with a soft cloth.
5. When the machine is not in use, open the water drain cap to completely drain the water
reservoir.
4
USING YOUR ICE MAKER
1. Select the size of the ice cube by pressing the “Select” button. If the room temperature is
lower than 60°F, it is best to select the small or medium ice size, otherwise the ice cubes
might stick together.
2. Open the cover, remove the ice basket and pour water into tank.
Keep water level below the level mark.
3. Press “Power” on the control panel to begin the ice making cycle.
4. The ice making cycle lasts 6 to 15 minutes, depending on the size of the ice cubes
selected.
5. While the ice maker is on, verify the water level periodically. If the water level is too low,
the ice maker will stop automatically, and the “Water” indicator will turn on.
Press the “Power” button, fill the unit with water, and press “Power” again.
Allow the refrigerant inside the compressor at least 3 minutes to settle before restarting.
6. The ice maker automatically stops working when the ice basket is full.
7. Change the water in the water reservoir every 24 hours to ensure a reasonable hygiene
level.
If the ice maker will not be used for an extended period of time, you should drain the water
from the reservoir.
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
Stop the ice maker, fill it with
water, and then restart it.
The “Water” indicator is
on.
Low water level.
The ice basket is full.
Remove ice from the ice basket.
The “Ice” indicator is on.
The “Water” and “Ice”
Check if the ice is blocking the
ice shovel, otherwise, consult a
qualified technician.
The ice shovel cannot
move.
indicators
flashing.
are
both
Stop the ice maker, and restart it
when the ice blocks melt. Select
the small ice button.
The ice cycle is too long.
The
ice
cubes
stick
together.
Change the water in the inner
tank. The ideal water temperature
is 45°-90°F.
The water temperature in
the inner tank is too low.
The ambient temperature Please run the ice maker in
or the water temperature is temperatures below 90°F and/or
The ice making cycle
seems normal but no ice is
produced.
too high.
pour colder water into tank.
Refrigerant liquid leakage.
A pipe in the cooling
system is blocked.
Consult a qualified technician.
Consult a qualified technician.
5
TECHNICAL SPECIFICATIONS & CIRCUIT DIAGRAM
TECHNICAL SPECIFICATIONS
Model
IP210
Power
115V/60Hz
Rated Current
Refrigerant
Net Weight
Size (HXWXD)
2.7 A
R134a/65g
30 Lb
14 3/4InX11 3/4InX14 1/2In
CIRCUIT DIAGRAM
ELECTRI CAL DI AGRAM
FOR I CE- MAKER
MODEL: HZB- 12
HZB-12/ S
St ar t
Rel ay
Sol enoi d
Val v e f or
I ce har vest
Mot or For
I ce shovel
MW
DC Fan Mot or
M
~
DC
Wat er
N
COMPRESSOR
SM
Pump
AW
L
Bl ue
Over l oad
Pr ot ec t or
G
POWER
SUPPLY
VALVE
MOTOR
+PUMP-
- FAN +
AC-N
Rel ay Rel ay
TRANSFORMER
AC-L
Rel ay
MI CRO SWI TCH
MI CRO SWI TCH
OPERATI ON PCB
LED2
LED1
SET
WATER DETECTI NG SWI TCH
MCU
LED3
SENSOR FOR
T1
CONTROLI NG FAN
LED6(ON/OFF)
MOTOR
T2
LED4(WATER)
LED5(ICE)
SENSOR FOR I CE
MAIN CONTROL PCB
ON/OFF
FULL DETECTI NG
7C
6
LIMITED WARRANTY
This EdgeStar product is warranted to be free from defective workmanship and materials for
the first year following the date of original purchase. Replacement parts will be supplied free of
charge for the first year following the date of original purchase. Labor will be performed free of
charge for the first 90 days following the date of original purchase.
WHAT IS COVERED
This warranty applies to the original purchaser only, and only covers defects in workmanship
experienced during operation of the product under normal service, maintenance, and usage
conditions. This warranty applies to the purchase and use of this product in residential settings
within the United States of America.
WHAT IS NOT COVERED
The following limitations apply to the coverage of this warranty:
Optional accessories, attachments, and appearance items are excluded from warranty
coverage, as is shipping damage, and any damage caused by improper voltage or any other
misuse, including abnormal service, handling, or usage.
This warranty does not cover normal wear and tear on parts or replacement of parts designed
to be replaced, e.g. filters, etc.
This warranty does not cover service trips to deliver, pick-up, repair, or install the product, or to
instruct in proper usage of the product.
Damages or operating problems resulting from abuse, operation outside environmental
specifications, uses contrary to instructions provided in the owner’s manual, accidents, vermin,
fire, flood, improper installation, unauthorized service, acts of God, unauthorized installation or
modification, or commercial use are excluded from warranty coverage.
Damage or loss of items stored inside the appliance are excluded from warranty coverage.
This warranty does not cover labor incurred 91 days or more after the date of original
purchase.
This warranty does not cover use of EdgeStar products in commercial settings.
DESCRIPTION OF WARRANTY SERVICE
All defective product components covered by this warranty will be repaired or replaced, at
EdgeStar’s option, free of charge on a mail-in basis to EdgeStar’s authorized repair facility
during the first 90 days from the date of original purchase.
All defective product components covered by this warranty will be repaired or replaced, at
EdgeStar’s option, on a mail-in basis to EdgeStar’s authorized repair facility during the time
period beginning on the 91st day from the date of original purchase and ending one year from
the date of original purchase. During this time period, parts will be supplied free of charge, but
labor charges will apply.
All replacement parts and units will be new, remanufacturered, or refurbished.
All products and components replaced by EdgeStar under warranty service become the
property of EdgeStar.
OBTAINING WARRANTY SERVICE
Contact EdgeStar for troubleshooting assistance and warranty service authorization at
1-866-319-5473. Please have your order receipt available to confirm the date of purchase.
Once an EdgeStar authorized representative has confirmed that your product is eligible for
warranty service, the product must be returned to an EdgeStar authorized repair facility.
The purchaser is solely responsible for prepaying all shipping related costs to and from the
repair facility.
EdgeStar is not responsible for damage resulting from shipper mishandling or improper
packaging.
Do not return defective product to the place of purchase.
THIS WARRANTY IS IN LIEU OF ANY OTHER WARRANTY, EXPRESS OR IMPLIED,
INCLUDING WITHOUT LIMITATION, ANY WARRANTY OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE. TO THE EXTENT ANY IMPLIED WARRANTY IS
REQUIRED BY LAW, IT IS LIMITED IN DURATION TO THE EXPRESS WARRANTY PERIOD
ABOVE. NEITHER THE MANUFACTURER NOR ITS DISTRIBUTORS SHALL BE LIABLE
FOR ANY INCIDENTAL, CONSEQUENTIAL, INDIRECT, SPECIAL, OR PUNITIVE DAMAGES
OF ANY NATURE, INCLUDING WITHOUT LIMITATION, LOST REVENUES OR PROFITS,
OR ANY OTHER DAMAGE WHETHER BASED IN CONTRACT, TORT, OR OTHERWISE.
SOME STATES DO NOT ALLOW THE EXCLUSION OF INCIDENTAL OR CONSEQUENTIAL
DAMAGES, SO THE ABOVE EXCLUSION MAY NOT APPLY TO YOU. THIS WARRANTY
GIVES YOU SPECIFIC LEGAL RIGHTS. YOU MAY HAVE OTHER RIGHTS THAT VARY
FROM STATE TO STATE.
8
|