1
Press STANDBY-ON on the projector or on the remote control to
put the projector into standby mode.
• Disconnect the power cord and unplug the power cord from the AC
socket after the cooling fan stops.
Do not attempt to exchange the lens
when the projector is installed
hanging from the ceiling. Injury may
occur if the lens cover and lens fall.
Installation Manual
AH-55201
AH-55301
AH-55401
AH-55501
AH-55601
AH-55701
AH-55801
STANDBY-ON button
Before exchanging the lens, reset
lens shift to the center position. (The
lens shift is located at the center in
the factory preset.)
H&V LENS SHIFT
button
When resetting the lens shift to the
center position, press H&V LENS
SHIFT and then press UNDO.
• The lens shift reset screen will be
displayed. Select “Yes” to reset.
UNDO button
Power cord
2
3
Remove the lens cover.
• Press the lens cover removal button (1). Slide the lens cover forward
(2).
Turn the lens in the direction of the arrow while pressing the lens
removal lever to pull the lens out.
Removal lever
2
1
|