User’s Guide for
Forever Flashlight
Rip Cord
TM**
Model No.
H630S
H630BK
Layout of Forever Flashlight
Rip Cord
Features
Our Forever Flashlight Rip Cord combines
an LED flashlight, emergency siren and charging capability
into one handy unit.
CHARGING LED
INDICATOR
ON/OFF/SIREN/
BLINKING LIGHT
•
•
Includes the new technology of a Rip Cord 3-Phase
Motor. This feature easily generates more power for
your Forever Flashlight Rip Cord than any other
technology. This allows a longer operation with less
pulling time.
Rechargeable batteries. This model does not need an
external power source. Instead it can be recharged by
spinning the built-in generator to recharge the internal
battery for optimum charging.
WRIST
BAND
SUPER
BRIGHT LED
FLASHLIGHT
•
•
•
•
•
•
•
Super-bright 5-LEDs visible for over a mile.
Super-bright green LED charging indicator.
Convenient pocket size, includes a sturdy wrist band.
Emergency siren.
Water-resistant.
RUBBER BACK
COVER
AC/DC Outlet jack for speedy charging through an outlet.
Cell phone charging option (comes with Nokia cable
and the connector set is available for $7.95 and suitable
for over 300 of the most popular cell phone models
all over the world).
DC 6V
•
Zero maintenance required.
INPUT
CELL PHONE
CHARGING
OUTPUT
RIP CORD
4
5
It is recommended to
charge your Forever
2. Lift the RUBBER BACK
COVER and locate your RIP
CORD.
How to Use
Flashlight Rip Cord for
three to five minutes either
before the first time you use
it or after a long period of
non-use of your unit.
Charging your unit
Charging the Forever
Flashlight Rip Cord
using your built-in
rechargeable batteries.
3. Hold the unit parallel
to the ground and pull the
RIP CORD. To achieve a par-
tial charge, pull the RIP
CORD approximately 80
times in one minute. Please
note, keep the unit parallel
and pull RIP CORD straight.
Your Forever Flashlight
Rip Cord includes two great
options to charge your unit.
For directions on each
option see right:
It is charged by pulling
the RIP CORD on the unit.
Your RIP CORD is located in
the rear of the flashlight
under the RUBBER BACK
COVER. For best results, fol-
low these steps in charging:
NOTES:
• Important. It is sug-
gested that pulling the RIP
CORD should not be allowed
to go past the red color of
the cord. This will damage
the unit and not allow for
maximum electricity.
The charge will not be
effective, if the RIP CORD is
pulled at an angle greater
than 30º (see Diagram 1,
page 6).
1. Turn the unit off.
Diagram 1
• While pulling the RIP
CORD of the Forever
Flashlight Rip Cord, an
indicator light will be on.
This will signify that the
charging is in the process.
Pull the RIP CORD at a
speed of approximately 80
times per minute. This will
provide 20-30 minutes of
flashlight light and one
minute of cell phone time.
The pulling force for the RIP
CORD must be constant and
of moderate speed.
6.6 LBS
Important. It is suggested that pulling
the RIP CORD should not be allowed to
go past the red color of the cord. This will
damage the unit and not allow for
maximum electricity.
7
6
•
If your unit is com-
properly. The recommended
pull speed would be 80
pulls per minute.
This energy saving light
uses minimal power con-
sumption. To use the flash-
light, first, set the LIGHT
SWITCH to either LIGHT/OFF/
SIREN/BLINK. The choice
between LIGHT, OFF, SIREN,
and BLINK, will adjust the
features of the flashlight.
Charging your
cell phone
pletely drained of energy,
you should pull the RIP
CORD again three to five
minutes. Keep in mind, that
if the Forever Flashlight
Rip Cord has not been uti-
lized for a long length of
time, it will cause the bat-
tery life to be shorter than
normal even after recharg-
ing.
Your Forever Flashlight
Rip Cord also has a great
additional feature –you can
charge your cell phone (or
other electrical items with
low voltage) anywhere you
are located. For best results,
follow these steps in charg-
ing your phone:
Charging your unit
using an AC/DC
adaptor.
Simply turn off your unit
and use your DC INPUT
JACK located on the side of
your unit, connect an
AC/DC adaptor cord and
then plug into an electrical
outlet. Your built-in batter-
ies will be fully charged
within three hours. Do not
leave plugged into an outlet
for more than 24 hours.
This will damage your
internal rechargeable batter-
ies.
The LIGHT switch will
allow a super bright 5 LEDS
light to brighten your path.
1. Pull your Forever
Flashlight Rip Cord for one
minute prior to plugging
your phone charge cord in.
In this case, recharge the
battery by pulling the RIP
CORD for three to five min-
utes. This will allow the
internal rechargeable bat-
tery to reactivate and charge
completely.
The SIREN switch will
allow a loud emergency
siren signal. At the same
time this will allow the LED
light to BLINK. What a great
feature for when you are in
need of help.
2. Connect the phone
charge cable into the DC
OUTLET JACK. This is locat-
ed on the side of the unit.
See page 4 for the location
of the CELL PHONE CHARG-
ING OUTPUT.
•
While charging by
To turn off the flashlight,
switch the LIGHT SWITCH to
OFF.
using the RIP CORD, remem-
ber to turn the unit off.
Using the flashlight
Your Forever Flashlight
Rip Cord includes an ultra
bright 5 LEDS light.
• If you utilize and pull
the RIP CORD slowly, the
batteries can not be charged
8
9
3. Plug the other end of
your phone charge cord into
your personal cell phone.
This can provide up to
two minutes of talking time
with this process. The
phone’s cell life can also be
extended by continuing the
pulling the RIP CORD during
the phone’s use.
Caution
Forever Flashlight Rip Cord generates a strong
magnetic field that surrounds it. Keep the unit at least one
foot away from medical devices, computers, magnetic
storage media, or other devices such as:
•
4. Once phone is plugged
into its charge cord contin-
ue to pull the RIP CORD for
one minute (approximately
80 pulls per minute).
• Pacemakers
• Credit cards
• Televisions
• Video tapes tube (CRT)
• Cassette tapes
• Computer discs
• Any device with a cathode ray
•
•
•
Do NOT attempt to remove the Light Emitting Diode (LED)
or any internal part.
Do NOT attempt to point the light into the human eye directly.
This strong light may cause physical damage to an eye.
Specifications
•
•
•
•
•
•
•
Outer dimension: 5'' x 1.75'' x 1.75''
Weight: 0.40 lbs
Do NOT attempt to put wrist band around any other parts of the
body, besides the wrist. Children under age should not use
the Forever Flashlight Rip Cord and should have
adult supervision at all times.
5mm LED: 5x @ 9200mcd, 0.5W
Power generator: 6V, 300mA
Siren sound output: 92dB (optional)
DC output: 4.5V, 600mA
DC input: 6V, 200mA
NOT ALL CELL PHONES USE THE SAME CURRENT TO CHARGE THE
CELL PHONE. THIS DEVICE OUTPUTS 400MA. YOU MUST CHECK
YOUR CELL PHONE MANUAL TO MAKE SURE THAT THE CHARGING
CURRENT FOR YOUR CELL PHONE WILL CHARGE BELOW 400MA.
EXCALIBUR ELECTRONICS, INC. IS NOT RESPONSIBLE FOR ANY
DAMAGE TO YOUR CELL PHONE IF A DIFFERENT CHARGING
CURRENT IS REQUIRED.
Excalibur Electronics reserves the right to make
technical changes without notice in the
interest of progress.
10
11
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Special Care & Handling
Always turn off the flashlight when charging.
•
•
Do not charge for more than 24 hours straight.
This could damage the unit’s recharging system.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable l interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more
of the following measures:
•
•
Avoid rough handling such as bumping or dropping.
Avoid extreme temperatures. For best results, use
between the temperatures of 39º F and 100º F
(4º C and 38º C).
Clean only using a slightly damp cloth. Do not use
cleaners with chemical agents.
•
•
Do not expose your Forever Flashlight Rip Cord to
direct sunlight or other heat source for any length
of time.
•
Do not expose your Forever Flashlight Rip Cord
to direct extreme cold, dusty or humid areas.
•
•
•
Reorient or relocate the receiving antenna.
•
•
Clean the lens with glass-cleaning products.
Do not use petroleum distillates (such as gasoline or
kerosene) or solvents such as acetone to clean
any part of the Forever Flashlight Rip Cord.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician
for help.
** This product uses rechargeable batteries for energy
storage that may need to be replaced after
extended use.
12
13
not allow exclusion of inci-
dental or consequential dam-
ages, so the above limitations
and exclusions in these
instances may not apply. The
only authorized service cen-
ter in the United States is:
Excalibur Electronics, Inc.
13755 SW 119th Ave
Miami, Florida 33186
U.S.A.
Phone: 305.477.8080
Fax: 305.477.9516
com
Ship the unit carefully
packed, preferably in the
original carton,
and send it pre-
paid, and ade-
quately insured.
Include a letter,
detailing the
complaint
and includ-
ing your
daytime telephone number,
inside the shipping carton. If
your warranty has expired
and you want an estimated
fee for service, write to the
above address, specifying the
model and the problem.
LIMITED 90-DAY WARRANTY
EXCALIBUR ELECTRON-
ICS, INC., warrants to the
original consumer that its
products are free from any
electrical or mechanical
defects for a period of 90
DAYS from the date of pur-
chase. If any such defect is
discovered within the war-
ranty period, EXCALIBUR
ELECTRONICS, INC., will
repair or replace the unit free
of charge upon receipt of the
unit, shipped postage prepaid
and insured to the factory
address shown at right.
wear and tear, inadequate
maintenance, commercial
use, or unreasonable use of
the unit. Removal of the top
panel voids all warranties.
This warranty does not cover
cost of repairs made or
attempted outside of the fac-
tory.
PLEASE DO NOT SEND
YOUR UNIT WITHOUT
RECEIVING
AN ESTIMATE
FOR SERVICING.
WE CANNOT
Any applicable implied war-
ranties, including warranties
of merchantability and fit-
ness, are hereby limited to 90
DAYS from the date of pur-
chase. Consequential or inci-
dental damages resulting
from a breach of any applica-
ble express or implied war-
ranties are hereby excluded.
Some states do not allow lim-
itations on the duration of
implied warranties and do
STORE YOUR UNIT!
The warranty covers normal
consumer use and does not
cover damage that occurs in
shipment or failure that
results from alterations, acci-
dent, misuse, abuse, neglect,
15
14
EXCALIBUR ELECTRONICS, INC.
13755 SW 119TH AVENUE,
MIAMI, FLORIDA 33186 U.S.A.
Phone: 305.477.8080
Fax: 305.477.9516
Play games live at:
H630S-H630BK (MA) FFlashRipCord 071906 V13
|