Introduced in the early 1970’s,
Gnip Gnop was a smash hit
game for kids of all ages. Now
it’s back and better than ever.
This game takes traditional ping
pong and turns it inside out.
Are you ready to Gnip Gnop?
( 2 game bases needed for this step )
Assembly
Step 1
• Snap the 2 game bases
together by lining up the
male and female ends
as shown below.
Game Play: Begin with three balls of the same color in
each player’s court. One player yells go. Then, smash the
buttons as fast as possible to send the balls flying through
the divider into your opponent’s court. The first player to
get all six balls into the opponent’s court wins the round.
The first to win three rounds in a row wins the game.
• Make sure the two ends
fit together tightly.
Variation: Play by rounds and the first to win 10 rounds
total wins the game. Take turns calling out the start of each
round before you play.
( 2 base feet needed for this step )
( 1 court divider needed for this step )
Assembly
Step 2
Assembly
Step 3
• Snap the foot into the
base of the game.
• Slide court divider
into the open slot
in the middle of the
game base.
• Repeat the process
for the opposite side
of the game base.
( 2 covers & 2 hinge pins needed for this step )
( 2 rubber bands needed for replacement )
Assembly
Step 4
Rubber
Bands
• Place the clear cover onto the game,
lining up the hinge on the cover and
the hinge on the court divider.
• Stretch the band over
the posts making sure
it stays under the
button extensions.
• Insert the two pins
into the hinge. Slide
one pin into each
end of the hinge.
Press firmly so
they fully
• Over time the rubber bands in your game will
wear down. To keep the balls flying at top speeds
periodically change the rubber bands by taking
off the old bands and sliding on new ones.
snap into
the hinge.
|