C2S980SEMSS
GE Café Free-Standing Dual-Fuel Range
Dimensions and Installation Information (in inches)
NOTE: Make gas connections on
the left side and electrical conections
on the right side of the
You must use the rear filler strip kit shipped with
the range or the optional accessory backguard
when installing these ranges
Recommended acceptable
electrical outlet area. Orient
the electrical receptacle so the
length is parallel to the floor.
30
cutout opening.
3
Note: Cabinets installed adjacent to slide-in
ranges must have an adhesion spec of at least
194° temperature rating.
4
3
8
3
Wall-Mounted
9
Optional Kits for Slide-In Gas Ranges:
(Available at additional cost)
Recommended area
for through-the-wall
connection of pipe
stub/shut-off valve.
Installation Information: Before installing, consult
installation instructions packed with product for
current dimensional data.
30"
This area allows
flush installation
to rear wall.
2-1/4
7-1/2
2
+
_
36-1/4" 1/4
37-1/4"
Product is shipped with 4-prong
plug. Recommended outlet is
a NEMA 14-50R receptacle.
Recommended area for
through-the-floor connection
of pipe stub/shut-off valve.
26-1/4"*
46-3/8"
Counter Cutout Dimensions (in inches)
If you are NOT using the
Filler strip or Backguard:
If you are using the
Filler strip or Backguard:
*Dimensions from wall
to front of closed door
handle is 29"
25
23-3/16
30
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
ge.com or call GE Answer Center® service,
800.626.2000.
30
All GE ranges are equipped with
an Anti-Tip device. The installation
of this device is an important,
required step in the installation
of the range.
Specification Revised 12/07
221218
|