Generac Portable Generator 005882 1 User Manual

GENERAC® GUARDIAN® SERIES  
STANDBY GENERATORS  
8 kW - 10 kW - 14 kW  
Air-Cooled Gas Engine Generator Sets  
Includes:  
Standby Power Rating  
Model 005882-1 (Steel - Bisque) - 8 kW 60Hz  
Model 005883-1 (Steel - Bisque) - 10 kW 60Hz  
Model 005884-1 (Steel - Bisque) - 14 kW 60Hz  
®
True Power Electrical Technology  
Two Line LCD Tri-lingual  
Digital Nexus™ Controller  
• Electronic Governor  
• External Main Circuit Breaker,  
System Status & Maintenance  
Interval LED Indicators  
• Sound Attenuated Enclosure  
• Flexible Fuel Line Connector  
• Composite Mounting Pad  
• Natural Gas or LP Gas Operation  
• 3 Year Limited Warranty  
• UL 2200 Listed  
FEATURES  
¡
INNOVATIVE DESIGN & PROTOTYPE TESTING are key components  
of GENERAC’S success in “IMPROVING POWER BY DESIGN.” But it  
doesn’t stop there. Total commitment to component testing, reliability  
testing, environmental testing, destruction and life testing, plus testing  
to applicable CSA, NEMA, EGSA, and other standards, allows you to  
choose GENERAC POWER SYSTEMS with the confidence that these  
systems will provide superior performance.  
¡
SOLID-STATE, FREQUENCY COMPENSATED VOLTAGE REGULATION.  
This state-of-the-art power maximizing regulation system is standard on  
all Generac models. It provides optimized FAST RESPONSE to changing  
load conditions and MAXIMUM MOTOR STARTING CAPABILITY  
by electronically torque-matching the surge loads to the engine. An  
unequalled ±1% voltage regulation.  
¡
¡
TRUE POWER® ELECTRICAL TECHNOLOGY: Superior harmonics and  
sine wave form produce less than 5% Total Harmonic Distortion for utility  
quality power. This allows confident operation of sensitive electronic equipment  
and micro-chip based appliances, such as variable speed HVAC.  
¡
¡
SINGLE SOURCE SERVICE RESPONSE from Generac’s extensive dealer  
network provides parts and service know-how for the entire unit, from the  
engine to the smallest electronic component.  
TEST CRITERIA:  
GENERAC TRANSFER SWITCHES. Long life and reliability are  
synonymous with GENERAC POWER SYSTEMS. One reason for this  
confidence is that the GENERAC product line includes its own transfer  
systems and controls for total system compatibility.  
PROTOTYPE TESTED  
SYSTEM TORSIONAL TESTED  
NEMA MG1-22 EVALUATION  
MOTOR STARTING ABILITY  
 
®
SPECIFICATIONS  
GENERATOR  
Model 005882-1 (8 kW) Model 005883-1 (10 kW) Model 005884-1 (14 kW)  
Rated Maximum Continuous Power Capacity (LP)  
Rated Maximum Continuous Power Capacity (NG)  
Rated Voltage  
8,000 Watts*  
7,000 Watts*  
10,000 Watts*  
9,000 Watts*  
14,000 Watts*  
13,000 Watts*  
240  
240  
240  
Rated Maximum Continuous Load Current – 240 Volts  
Total Harmonic Distortion  
33.3 LP/29.2 NG  
Less than 5%  
41.6 LP/37.5 NG  
Less than 5%  
58.3 LP/54.2 NG  
Less than 5%  
Main Line Circuit Breaker  
35 Amp  
45 Amp  
60 Amp  
Phase  
1
1
1
Number of Rotor Poles  
2
2
2
Rated AC Frequency  
60Hz  
60Hz  
60Hz  
Power Factor  
1
1
1
Battery Requirement (not included)  
Group 26R 12 Volts and 525  
Group 26R 12 Volts and 525  
Group 26R 12 Volts and 525  
Cold-cranking Amperes Minimum Cold-cranking Amperes Minimum Cold-cranking Amperes Minimum  
Unit Weight (Pounds/Kilos)  
340/154.2  
387/175.4  
439/199.1  
Dimensions (L x W x H) Inches/mm  
Sound output in dB(A) at 23 ft. with generator operating at normal load  
48 x 25 x 29 (1218 x 638 x 732)  
63  
62  
66  
ENGINE  
Model 005882-1 (8 kW) Model 005883-1 (10 kW) Model 005884-1 (14 kW)  
Type of Engine  
GENERAC OHVI  
GENERAC OHVI V-TWIN  
GENERAC OHVI V-TWIN  
Number of Cylinders  
Displacement  
1
410cc  
2
530cc  
2
992cc  
Cylinder Block  
Aluminum w/Cast Iron Sleeve  
Overhead Valve  
Solid-state w/Magneto  
Electronic  
Aluminum w/Cast Iron Sleeve  
Overhead Valve  
Solid-state w/Magneto  
Electronic  
Aluminum w/Cast Iron Sleeve  
Overhead Valve  
Solid-state w/Magneto  
Electronic  
Valve Arrangement  
Ignition System  
Governor System  
Compression Ratio  
Starter  
9.4:1  
12 Vdc  
9.5:1  
12 Vdc  
9.5:1  
12 Vdc  
Oil Capacity Including Filter  
Operating RPM  
Approx. 1.5 Qts./1.4L  
3,600  
Approx. 1.7 Qts./1.6L  
3,600  
Approx. 1.9 Qts./1.8L  
3,600  
Fuel Consumption  
Natural Gas  
cu.ft./hr.  
1/2 Load  
Full Load  
77  
102  
156  
139  
156  
220  
3
Liquid Propane ft /hr (gal/hr) [Liter/hr]  
1/2 Load  
Full Load  
34 (0.94) [3.56]  
62 (1.68) [6.36]  
46 (1.25) [4.73]  
70 (1.93) [7.31]  
58 (1.56) [5.91]  
84 (2.30) [8.71]  
Required fuel pressure to generator fuel inlet at all load ranges - 5 to 7 inches of water column for natural gas, 10 to 12 inches of water column for LP gas  
For Btu content, multiply ft3/hr x 2520 (LP) or ft3/hr x 1000 (NG)  
CONTROLS  
2-Line Plain Text LCD Display (10 & 14 kW)  
Mode Switch  
Simple user interface for ease of operation.  
-Auto  
Automatic Start on Utility failure. 7 day exerciser.  
-Off  
Stops unit. Power is removed. Control and charger still operate.  
-Manual/Test (start)  
Start with starter control, unit stays on. If utility fails, transfer to load takes place.  
Programmable start delay between 10-30 seconds  
Engine Start Sequence  
Standard  
Cyclic cranking: 16 sec. on, 7 rest (90 sec. maximum duration).  
Engine Warm-up  
5 seconds  
Engine Cool-Down  
1 minute  
Starter Lock-out  
Starter cannot re-engage until 5 sec. after engine has stopped.  
Smart Battery Charger  
Standard  
Standard  
Standard  
Standard, 72Hz  
Standard  
Standard  
Standard  
Standard  
Standard  
Standard  
Standard  
Standard  
Standard  
Standard  
Automatic Voltage Regulation with Over and Under Voltage Protection  
Automatic Low Oil Pressure Shutdown  
Overspeed Shutdown  
High Temperature Shutdown  
Overcrank Protection  
Safety Fused  
Failure to Transfer Protection  
Low Battery Protection  
50 Event Run Log  
Future Set Capable Exerciser  
Incorrect Wiring Protection  
Internal Fault Protection  
Common External Fault Capability  
Rating definitions - Standby: Applicable for supplying emergency power for the duration of the utility power outage. No overload capability is available for this rating. (All ratings in accordance with BS5514,  
ISO3046 and DIN6271). * Maximum wattage and current are subject to and limited by such factors as fuel Btu content, ambient temperature, altitude, engine power and condition, etc. Maximum power  
decreases about 3.5 percent for each 1,000 feet above sea level; and also will decrease about 1 percent for each 12° C (10° F) above 15.5° C (60°F).  
 
Generac® Guardian® Series Guardian Standby Generator - 8 kW - 10 kW - 14 kW  
AVAILABLE ACCESSORIES  
Model #  
Product  
Discription  
Every standby generator requires a battery to start the system. Generac offers the  
recommended 26R wet cell battery for use with all air-cooled standby product.  
5819  
26R Wet Cell Battery  
If the temperature regularly falls below 32° F, install a cold weather kit to maintain  
optimal battery temperature. Kit consists of battery warmer with thermostat built  
into the wrap.  
5948 - 8 & 10kW  
5947 - 14kW  
Cold Weather Kit  
Auxiliary Transfer Switch  
Contact Kit  
The auxiliary transfer switch contact kit allows the transfer switch to lock out a  
single large electrical load you may not need.  
5621  
5703  
Paint Kit  
Bisque Kit  
5662 - 8kW  
5663 - 10kW  
5664 - 14kW  
Generac's scheduled maintenance kits provide all the hardware necessary to  
perform complete routine maintenance on a Generac automatic standby generator.  
Scheduled Maintenance Kit  
Nexus Wireless Remote  
Completely wireless and battery powered, Generac's Nexus wireless remote monitor  
provides you with instant status information without ever leaving the house.  
5928  
5951  
5937  
Remotely control generator functions with the advanced model's LCD display. In  
addition to remote testing of the generator, set the excercise cycle and maintenance  
interval reminders.  
Advanced Nexus Wireless  
Remote  
DLM Modules are used in conjunction with the Nexus Smart Switch to increase  
its load management capabilities. It gives the Nexus Smart Switch additional load  
management flexibility not found in any other transfer switch.  
DLM Load Control DLM  
Module (50 Amps)  
Design and specifications subject to change without notice. Dimensions shown are approximate. Contact your Generac dealer for certified drawings. DO NOT USE THESE DIMENSIONS FOR INSTALLATION PURPOSES.  
637.6  
[25.1]  
1218  
[47.9]  
731.9  
[28.8]  
®
642  
[25.3]  
76.2 [3.0]  
PEA GRAVEL  
MINIMUM  
1226  
[48.3]  
FRONT VIEW  
LEFT SIDE VIEW  
®
Generac Power Systems, Inc. • S45 W29290 HWY. 59, Waukesha, WI 53189 • generac.com  
©2012 Generac Power Systems, Inc. All rights reserved. All specifications are subject to change without notice. Bulletin 0186170SBY-G Printed in U.S.A. 07/11/12  
 

Ericsson Telephone LBI 39169 User Manual
FujiFilm Digital Camera 16316891 User Manual
Fujitsu Laptop S6231 User Manual
Fujitsu Printer FTP 631MCL201 User Manual
Galil Projector DMC 2X00 User Manual
GE Clothes Dryer DBXR453 User Manual
GE Telephone 29480C User Manual
GE Telephone 20909690 User Manual
Giant Water Pump SP100W User Manual
GOJO Indoor Furnishings FMX 12 User Manual