TABLE OF CONTENTS
Battery Installation
3
4
4
5
5
6
6
7
7
8
8
9
9
Fox Sports Soccer Layout
Button Functions
Rules & Scoring
How to Play
Two-Player Mode
Troubleshooting
Battery Safety
FCC Regulations
Special Care & Handling
90-Day Limited Warranty
Shipping Your Unit
Expired Warranty
5. Place the tabs of the battery
compartment into their slots, and
snap the compartment door into
place.
BATTERY INSTALLATION
Your Fox Sports Soccer game
requires 2 AA batteries. Follow
the steps below to install the
batteries.
6. Screw the lid shut.
7. Press the RESET button
using a small pointed object
after new batteries are installed.
1. Turn the game over so the
topside is face-down on a soft
surface. You will see the battery
compartment at the top.
2. Remove the screw using a
small Phillips screwdriver.
3. Lift off the battery
compartment lid.
4. Install the two batteries
carefully matching the polarity
(+ and -) with the diagram inside
the battery compartment.
FOX SPORTS SOCCER LAYOUT
2 Player Card Socket
Attach connecting cord here
RESET
START
ON / OFF
SOUND
PAUSE
DIRECTIONAL
BUTTONS
A KEY
B KEY
BUTTON FUNCTIONS
ON/OFF: Press firmly to turn
unit on or off.
RESET: Press to clear
malfunctions or to reset the
game as desired.
START: Starts the game.
PAUSE: Momentarily halts
the game. Press START to
continue the game.
SOUND: Press to turn sound
on or off.
DIRECTIONAL PAD (Up,
Down, Left and Right as
below).
UP: Press to move player up.
DOWN: Press to move player
down.
A: On offense press the A key
LEFT: Press to move the
to shoot the ball when near the player left.
goal. On defense press A to
steal the ball
RIGHT: Press to move the
player right.
B: Press the B key to pass the
ball on offense, or to switch
players on defense.
RULES & SCORING
• The game is set to one-
player mode by default.
HOW TO PLAY
Follow the steps below to get
started.
• For two-player mode, the
player who presses the START
key first after the units are
connected and simultaneously
turned on will control the team
in white. The team in black
always gets the ball first.
• Each team has three players.
• Each match lasts
1. After inserting new batteries,
press the RESET key to turn
the unit on.
2. Press the START button to
begin the game. The active
player flashes on screen.
3. Press the directional/arrow
keys to control your player’s
movement.
approximately six minutes.
Follow the timer in upper right
quadrant of the screen.
• The game will end when the
time has expired, or when one
team has five more points than
the other
• If the score is tied after time
runs out, an additional two minutes
of play time will be added.
Offense
1 To pass you must first hold
down the B key and then
choose the direction you wish
to pass by pressing LEFT
RIGHT UP, or DOWN on the
directional pad
For example: if a team
• The offensive players begin
at the bottom of the screen.
• If a team wins five matches in
a row, a trophy will be awarded.
The next match will be at a
faster speed.
member is located at the
right, press and hold the B
key. Then press the RIGHT
DIRECTIONAL key to pass
the ball to your team member.
2 Press the A key to shoot
the ball when the player
approaches the goal.
Defense
1. Press the directional key to
block the offense.
2. To steal the ball, approach
the player with the ball and
press the A key
Goalkeeper
1. Press the LEFT and RIGHT
keys to control the goalkeeper.
TWO-PLAYER MODE
1. Turn both units off.
2. Connect both units with the
two-player connection cord. Be
sure to insert the cord in the
right direction.
3. Press the ON/OFF key to
turn the units on.
4. Press START on either of
the two units to start the 2-
player game.
NOTE: The person who
presses START first will begin
play in the white uniforms.
TROUBLESHOOTING
Press the RESET button on
the front using a small pointed
object if the game
malfunctions.
BATTERY SAFETY
• 2-AA batteries not included.
• Do not use rechargeable batteries.
• Do not mix old and new batteries.
• Do not mix alkaline, standard or rechargeable batteries.
• Battery installation should be done by an adult.
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries should be removed from the
• Battery installation should be done by an adult.
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries should be removed from the toy before
being charged (if removable).
• Rechargeable batteries are only to be charged under adult
supervision (if removable).
• Only install batteries of the same type and polarity.
• Remove dead batteries from the toy to prevent leakage.
• Do not short-circuit the supply terminals.
FCC REGULATIONS
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference that may cause undesired
operation.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are de-
signed to provide reasonable interference in a residential installation. This equip-
ment generates, uses and can radiate radio frequency energy, and if not installed
and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interfer-
ence to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
SPECIAL CARE AND
HANDLING
from alterations, accident,
misuse, abuse, neglect,
• Avoid rough handling such
as bumping or dropping.
• Avoid moisture and extreme
temperatures. For best
results, use between the
temperatures of 39 degrees
F and 100 degrees F (4
degrees C and 38 degrees C).
• Clean using only a slightly
damp cloth. Do not use
cleaners with chemical
agents.
wear and tear, inadequate
maintenance, commercial
use, or unreasonable use of
the unit. Removal of the top
panel voids all warranties. This
warranty does not cover cost
of repairs made or attempted
outside of the factory.
Any applicable implied
warranties, including
warranties of merchantability
and fitness, are hereby limited
to 90 DAYS from the date of
purchase. Consequential or
incidental damages resulting
from a reach of any applicable
express or implied warranties
are hereby excluded. Some
states do not allow limitation
on the duration of implied
warranties and do not allow
exclusion of incidental or
consequential damages,
so the above limitation and
exclusions in these instances
may not apply. The only
90-DAY LIMITED
WARRANTY
EXCALIBUR ELECTRONICS,
INC., warrants to the original
customer that its products
are free from any electrical
or mechanical defects for a
period of 90 DAYS from the
date of purchase. If any such
defect is discovered within the
warranty period, EXCALIBUR
ELECTRONICS, INC., will
repair or replace the unit free
of charge upon receipt of the
unit, shipped postage prepaid
and insured to the factory
address shown in this booklet.
The warranty covers normal
consumer use and does not
cover damage that occurs in
shipment or failure that results
authorized service center in
the United States is:
EXCALIBUR ELECTRONICS., INC
13755 SW 119th Ave
Miami, Florida 33186 USA
Phone: 305.477.8080
Fax: 305.477.9516
SHIPPING YOUR UNIT TO
EXCALIBUR ELECTRONICS, INC
• Ship the unit carefully
packed, preferably in the
original carton, and send
it prepaid and adequately
insured.
• Include a detailed letter with
the following:
o the specific complaint
o your daytime telephone
number
o your address
EXPIRED WARRANTY
If your warranty has expired
and you want an estimated fee
for service, write to the above
address, specifying the model
and the problem.
NOTE: Please do not send
your unit without first receiving
an estimate for servicing from
EXCALIBUR ELECTRONICS,
INC,. Contact us before sending
your unit. We cannot store
your unit!
Excalibur Electronics, Inc., reserves the right to make technical
changes without notice in the interest of progress.
|
